🏎️ 47Inch(1.2M) Carbon Fiber LED Spoiler Light Strip | 5-in-1 Sequential Flashing Third Brake Tail Light for Universal Cars

🚗 This flexible LED spoiler strip upgrades your vehicle’s rear lighting with five unique light modes, adding sporty carbon fiber styling while boosting rear traffic warning safety for daily driving.

💡 Five Custom Sequential Lighting Functions

Equipped with built-in controller to deliver five practical working modes: steady low-bright driving lamp, full bright brake warning light, left sequential flowing turn signal, right sequential flowing turn signal, center-out emergency hazard flash. Dynamic flowing illumination grabs following drivers’ attention efficiently to avoid rear-end collisions.

✨ High-Density 171pcs 2835 SMD LED Beads

Packed with 171 premium 2835 LED chips featuring low light decay and long service lifespan, brightness matches factory OEM taillight standard. Premium carbon fiber textured outer casing brings aggressive customized sport appearance to your car trunk or roof spoiler.

💧 IP67 Full Waterproof Flexible Rubber Build

Made of bendable high-density soft rubber with IP67 waterproof grade, fully dustproof and shock resistant, it works stably under heavy rain, snow or muddy driving conditions without water infiltration damage.

📏 Precise 1.2M(47.24 Inch) Universal Size & Dual Mount Options

Total length 1.2 meter /47.24 inch, pre-programmed integrated circuit so the strip cannot be cut arbitrarily. Two available installation positions: mount as roof third brake lamp or rear trunk spoiler lip light, fits most sedan, SUV, pickup and van models.

Step-by-Step Installation Guide

1. Remove the fixing snaps of right rear taillight inside trunk, disconnect the original taillight wiring harness.
2. Complete wire connection according to wiring definition: red for positive pole, black for ground negative, green for ACC, white for brake line, yellow for turn signal line, then test all five light functions to confirm normal operation.
3. Fully wipe and dry the trunk/spoiler sticking surface thoroughly, peel off backing tape and attach the light strip, press down tightly for 10 seconds to secure. Avoid water contact within 48 hours after installation for better tape adhesion.
4. Neatly tuck away excess wiring, fix cables with cable ties or adhesive tape then reinstall taillight snaps to finish installation.

Product Specifications

Material: Flexible rubber + carbon fiber surface finish
Operating Voltage: DC 12V
LED Model: 2835 SMD, total 171 beads
Waterproof Level: IP67
Item Length: 1.2 Meters /47.24 Inch
Included Accessories: 1 x LED spoiler light strip + 1 x dedicated control adapter

Package Includes

1 x 1.2M(47.24Inch) Carbon Fiber LED Spoiler Light Strip, 1 x Wiring Controller Adapter